入了JBL MR 900系列 16页起逐步上专业箱资料

martin_wu

Behind horn colomn, Woofer colomn.

Each of the 4 colomn is about 1000 Kg ! (total 4000Kg)

Speakers are desiged and built by Klinger Favre

号角阵列后面是低音阵列，每个阵列重达1吨！！！

martin_wu

交易区新帖推荐

left side with the table where sources are .

CD drive is Teac P0, Upsampling and clock master done by DCS, Room correction done by TACT RCS2.0, Dogital Pream is Accuphase.

音源

martin_wu

放大器：

martin_wu

all electronics and crossover for each side

Sub bass: amplified by a Gryphon Solo mono bloc - 0 => 71Hz slope —\ 48

4 woofer using JBL 2227H (push pul with 3m Horn)

Mid bass: amplified by a Gryphon Solo mono bloc - 71=> 180Hz slope 48 /—\ 48

2 woofer using JBL 2227H (with 1,80m Horn)

High bass: amplified by a Gryphon Solo mono bloc - 180=> 400Hz slope 48 /—\ 24

2 mid-bass 10 " Horn using TAD 1201H

Low midrange: amplified by a Cary CAD 1610 SE mono bloc - 400=> 2000Hz slope 24 /—\ 24

1 drivers 3" JBL 2490H

Midrange: amplified by a Cary CAD 1610 SE mono bloc- 2000 => 5000Hz slope 24 /—\ 24

1 driver JBL 2" JBL 2450 H

High Midrange one : amplified by a Cary CAD 1610 SE mono bloc- 5000=> 10000Hz slope 24 /—\ 24

1 driver JBL 1.5" JBL 2451H

High Midrange one : amplified by a Cary CAD 1610 SE mono bloc- 10000=> 14000Hz slope 24 /—\ 24

1 driver JBL 1" JBL 2426H

Tweeter: amplified by a Cary CAD 1610 SE mono bloc - 14000 Hz => top slope 24 /—

2 driver JBL 2404 JBL + 1 super tweeter Klinger Favre

系统构成

martin_wu

电源：

martin_wu

交易区新帖推荐

不断改良：

[ 本帖最后由 martin_wu 于 2008-1-7 20:45 编辑 ]

martin_wu

高音

martin_wu

金嗓子A50

martin_wu

加力
Some Cary CAD 1610 SE tube amplifiers

[ 本帖最后由 martin_wu 于 2008-1-7 20:40 编辑 ]

martin_wu

贵丰

martin_wu

大胆管：
I am holding a 1610 tube from the Cary Audio CAD 1610 SE, with Ramon Ribo on the left listening to my explanations

[ 本帖最后由 martin_wu 于 2008-1-7 20:42 编辑 ]

martin_wu

高音正面：

martin_wu

正面：

martin_wu

又是一组号角：

martin_wu

另一套号角系统：
五路全号角系统，连低音也是号角！！！

[ 本帖最后由 martin_wu 于 2008-1-7 20:54 编辑 ]