求HX950参数调教设置~

junkstory

对三星没啥好感，就随便买了台索尼，本来想默认设置就算了，但无意看到网上说默认伽玛只有1.8，调一下能变2.2，碟中碟屏摄的也不错，谁知道该怎么调呀？

pzhahaha

{:soso_e104:} 求坦克吧  给我 850的参数， 的确看电影的感觉好很多

aadundun

同求，和850的设置一样可以？

chncwk

CNET上还真没找到。
AVS上的，不是仪器出来的，929的也许更靠谱些。
http://www.avsforum.com/t/1435724/sony-xbr-hx950-settings-thread

aadundun

另外，hx950的工程模式已解决，参照下一楼

泰山南

进入索尼电视工程模式：
开机状态
，按照以下步骤操作：

顺序按遥控器按键五下,动作要连续：

1. 右上角绿色"电视电源"键

2."屏显"（圆弧右上角的小"屏显"字, 不是大的"屏显模式"）

3. 数字"5"

4. 音量减号"—"

5. 同1 , 右上角绿色"电视电源"键



稍后，显示工程菜单

左下角最后一行：
XXXXX——XXXXX——XXXXX

具体表示：开机时间——开机次数——待机时间

aadundun

又试了试，10次以上开关机，终于试出来

aadundun

chncwk 发表于 2012-11-11 17:35
CNET上还真没找到。
AVS上的，不是仪器出来的，929的也许更靠谱些。
http://www.avsforum.com/t/1435724/ ...

已参考

aadundun

记录一下，备用
Scene Mode: General
Picture Mode: Standard
Backlight: 5
Picture: Max
Brightness: 53 (when Gamma is on -2), 52 (when Gamma is set to 0)
Color: 56 (for most content), 60 (for some content)
Hue: 0
Color Temperature: Neutral
Sharpness: 24-36 (for Games and Computer), 50 (for everything else) - Above 50 = Edge Artifacting, and just gets worse as you go higher.
Noise Reduction: Off
MPEG Noise Reduction: Off
Dot Noise Reduction: Off
Reality Creation: Manual with Resolution 20 and Noise Filering Min OR Off, based on preference. (Sometimes Resolution at 10 looks better for some video games)
Smooth Gradation: Medium
MotionFlow: Standard
CineMotion: Auto 1 (for nearly all movies and most games), OFF (for some video games)
Black Corrector: Off
Advanced Contrast Enhancer: OFF
Gamma: -2 (for most movies and/or normal content) , 0 (for darker movies and/or content) (when set to 0, put "Brightness" to 52)
LED Dynamic Control: Standard
Auto Light Limiter: Off
Clear White: Off
Live Color: Off
White Balance: R-Gain: -2, G-Gain: -6, B-Gain 0, R-Bias -2, G-Bias 0, B-Bias 0
Detail Enhancer: Medium
Edge Enhancer: Off
Skin Naturalizer: Off
Display Area: FULL PIXEL
ALL ECO SETTINGS OFF
HDMI Dynamic Range: Auto
Color Matrix: Auto

aadundun

•Enable 1:1 pixel mapping:
Home > Settings > Picture & Display > Screen > Auto Display Area = “Off” and Display Area = “Full Pixel.”

•Disable the ambient light sensor:
Home > Settings > Preferences > Eco > Light Sensor = "Off."

•Backlight is typically set near "Min" for a dim viewing environment and higher, as needed, for a bright viewing environment.

•Picture adjusts the contrast and is typically set at or near "Max."

•A Color Temperature of "Warm 2" is near the 6500 Kelvin standard.

•Motionflow is typically set to "Off" to preserve natural 24p film cadence (with its native judder). The other options apply varying degrees of frame interpolation / backlight scanning / black frame insertion.

•CineMotion enables an inverse telecine circuit on interlaced content. "Auto 2" reverses 3:2 pulldown to reconstruct the orginal 24 fps (film) cadence. "Auto 1" reverses 3:2 pulldown with mild smoothing (interpolated frames).

•Gamma is typically set between -1 and 0, depending on the brightness of the viewing environment.

•LED Dynamic Control is typically set to "Standard" to fully enable backlight dimming.

•Remaining controls (brightness/color/hue/sharpness) are typically left at their midrange default setting.

sxg

留个记号，备用。

loio

记录备用一下[s:97]

baocdss

mark 下也，很有用的信息

平板彩电专家

那明天拿65寸的试试

皇家收尸达

在用HX950，很满意！